Alkalmazási terület The current and temperature limiter Y is used wherever, on one hand, protection against overtemperatures as well as against overcurrents is required, and on the other hand, automatic switch on function of the device to be protected - subsequent to a follow-on cooling down period - is prohibited or undesired. We work with you exploring the right material mixes and setting to work in your application with regards to motor, positioning, heat dispensing and materials. Mounting brackets or clips available. Funkció The current and temperature limiter Y operates very fast (less than 3 seconds) and current sensitiv. Temperature detection is realized by bimetal disk which was first dimensioned in accordance with the required cut-off temperature. When this fixed cut-off temperature TA is reached, this bimetal disk will snap , breaking a contact system and thereby interrupting the electric circuit of the device to be protected. Due to the current sensitivity, the switch does not have to be mounted directly on the heat source. Current sensitivity In the case of an obvious current increase (blocking current or short-circuit current) a resistor, lying in series with the contact system inside the limiter, heats the bimetal disk to its cut-off temperature TA very quickly. When this cut-off temperature TA is reached, the bimetal disk will snaps suddenly and breaks the contacts of the switch. To get an optimal adjustment in accordance to the application there are wide range of resistor values are available. Self-holding function By means of a resistor heat is generated by the supply voltage applied after breaking the contact. This heat prevents any decrease in temperature below the value necessary for the cut-in temperature TE. In this was, the switch will keep its contact open, irrespective of its ambient temperature. Cut-in of the switch, and thus closing the circuit, will be possible only after disconnection from the supply voltage. Datasheet Y Current-Time behaviour Tripping resistor table Self-hold Resistor table Mounting bracket 506005 Mounting brackets 506000-506003 U-Clip 506100 U-Clip 506101 Érdeklődjön most